Is there an easy way to check which plug goes to which injector? I might be able to figure it out based on the wire lengths but the 1st two (closest to the window) aren't obvious. I'm hoping an ohm meter from the distributor and then to the plug connector might work. I'd also like to check that wire connector are good because some of the clips aren't in great shape and the wires have electrical tape near the connector.

honestly it really doesnt matter as the injectors are batch fired, but when you lay ouy the harness it is obvious which plug goes to which injector

BEEK wrote:honestly it really doesnt matter as the injectors are batch fired, but when you lay ouy the harness it is obvious which plug goes to which injector

Yep. Figured that out about 10 minutes ago. Thanks.

Richard