Fitting after market wheels ??

jamie mccormick · Post by **jamie mccormick** » Wed Jul 25, 2007 8:05 pm

Trying to fit after market wheels on my 80 spider .Previous owner had replaced locating pins on rotor face with bolts that won't allow new wheel to fit flush on rotor face.So can I just chuck the bolts or do they do something ??or do I need some sort of spacer for them?...bought them from fiat wheels.com.

So Cal Mark · Post by **So Cal Mark** » Wed Jul 25, 2007 11:57 pm

you can do without the bolts, they do help keep the lug bolt holes aligned between the rotor and hub when the wheels are off

Hawke187 · Post by **Hawke187** » Thu Jul 26, 2007 9:52 pm

What I did was counter sink the centering pin holes and install bolts that match the counter sink with allen key holes.

Now the spacers stay in place and makes changing the tires much easier than trying to balance both at the same time.

jamie mccormick · Post by **jamie mccormick** » Fri Jul 27, 2007 9:19 am

thanks guys for the help,much appreciated!!