Front Lower Valance Replacement?

[Landhawk]

Has anyone replaced the front lower valance?

The one on my car is pretty beat up, especially on the lower part of the valance (see below) and I was thinking it would be much easier to replace than repair.





However, I could only find one source of the panel:

(http://www.vickauto.com/newstore/index. ... ts_id=2552)

Also, this panel doesn't appear to be bolted on, it looks more like its tack welded somehow. Thought I would ask here to see if anyone has any experience / suggestions with this area.

Thanks

[engineerted]

Yes, that panel is welded in place. If it is not rusted thru, then just sand it, hammer it, fill it and paint it. Then get yourself a chin spoiler.

Ted

[124JOE]

well put!!

mine was beat up "no rust"
the body guy grabed a set of dolly hammers and straightened it right out

sand it, stop the rust. seal it ,prime and fill with a bit of bondo,
sand again then ask if it needs replacement.