spider project w/vg-30

Fixitoni · Post by **Fixitoni** » Mon Jan 29, 2007 11:48 pm

On ebay, unfinished. Always wondered if that would be hard to do, or practical. Still seems sacrilegious even if it would be fast...would you have to weld the doors to keep the body flex down? have to get Mark "SoCal to make the headers fershure...or elves.

So Cal Mark · Post by **So Cal Mark** » Tue Jan 30, 2007 12:24 am

what's the link?

Fixitoni · Post by **Fixitoni** » Tue Jan 30, 2007 9:21 am

link http://cgi.ebay.com/ebaymotors/1977-FIA ... dZViewItem

So Cal Mark · Post by **So Cal Mark** » Tue Jan 30, 2007 10:31 am

thanks for the link. That's an early v6 that used a throttle body. The whole project looks pretty rough though

Fixitoni · Post by **Fixitoni** » Tue Jan 30, 2007 11:22 am

-GRINS- didn't SAY it's pretty! Shortblock alone weighs more than stock engine,likely. Couldn't tell from photo, whats up with the r.f. fender? -torched? maybe not...poor car deserved better. If datsun/nissan roadsters were as common and cheap as ragged spiders we'ld be seeing Them with such setups. Rail frame instead of unibody makes it more practical.

Fixitoni · Post by **Fixitoni** » Tue Jan 30, 2007 11:25 am

How do I fix that, likely annoying to others besides me. duh.

Fixitoni · Post by **Fixitoni** » Tue Jan 30, 2007 11:26 am

text running off the page is what I mean. will fix if can.

mbouse · Post by **mbouse** » Wed Jan 31, 2007 4:20 pm

Just my opinion, but run....far away from this one. the picture (only one?) and a partial at that, is purposely vague.

spider project w/vg-30

spider project w/vg-30

spider vg-30

"unfinished"

my text runs off the frame?