4 bolt conv test pipe

wengr · Post by **wengr** » Mon Jun 29, 2009 2:38 pm

Does anyone offer a cat converter test pipe with 4 bolt flanges? all I find are 3 bolt flanges.

narfire · Post by **narfire** » Mon Jun 29, 2009 8:42 pm

When I bought mine from Ital Motors in Edmonton, It had ANSA written on it. Perhaps a muffler place might be able to help. I found it a bit short in that I had to bend the pipe a bit as it goes over the axle so it would not rub on the panhard rod and frame. Yeup 4-bolt.
Chris

So Cal Mark · Post by **So Cal Mark** » Mon Jun 29, 2009 10:02 pm

and you expected Ansa aftermarket to fit? lol Their stuff is the worst. The oem is far different than the aftermarket stuff

narfire · Post by **narfire** » Mon Jun 29, 2009 11:53 pm

So Cal Mark wrote:and you expected Ansa aftermarket to fit? lol Their stuff is the worst. The oem is far different than the aftermarket stuff

Actually the header part fit great. bolted right on,good clearance with the block and steering idler. The two into one fit well , with the trans. support and the down pipes attatchment point being where they were supposed to. The cat. plug/pipe should have been 1/2 to 3/4 inch longer that was all. This was $500 cdn.,something I could not pass up. Marc's would be best,I'm sure,but the CDN $ is up and down more often than a whores drawers,giving us canuckle heads some pause in bigger purchases.

mbouse · Post by **mbouse** » Tue Jun 30, 2009 7:34 am

http://www.fiatparts.com

Bruce Matthews will be pleased to assist you

4 bolt conv test pipe

4 bolt conv test pipe

Re: 4 bolt conv test pipe

Re: 4 bolt conv test pipe

Re: 4 bolt conv test pipe

Re: 4 bolt conv test pipe