Looks good. How easy was the Lancia intake manifold installation?
Thanks!
It was easy although you need to be careful to get the correct manifold as many FWD Lancia manifolds look similar. I believe this one is from a Dedra.
All the basics are the same, bolt pattern, injector angle, port spacing, etc.
I also had an Integrale manifold and the inlet angle (where the TB mounts) was different and contacted the cam wheels. If you can weld cast aluminum you could make this work. In the end, a modified Integrale unit may be a good choice as it would provide some control over TB angle and therefore provide greater clearance for the rad inlet hose.
Even the Dedra unit I have is VERY close. See pictures above, I had to cut away some of the timing belt cover.
