Original Jack placement and install?

General chat about the car goes in here.
Post Reply
Betis
Posts: 109
Joined: Mon Nov 30, 2015 11:17 pm
Your car is a: 1981 Fiat 124 Spider FI

Original Jack placement and install?

Post by Betis »

How does the jack go and how is it held. Any pictures and instructions will be appreciated.
Thanks in advance.
vandor
Posts: 3996
Joined: Sat May 23, 2009 1:23 pm
Your car is a: 1971 124 Spider
Location: Texas, USA

Re: Original Jack placement and install?

Post by vandor »

On most Spiders up to 1982 it goes on the right side rear wheel well and is held by a rubber strap.
Csaba
'71 124 Spider, much modified
'17 124 Abarth, silver
http://italiancarclub.com/csaba/
Co-owner of the best dang Fiat parts place in town
User avatar
4uall
Posts: 4145
Joined: Mon Sep 26, 2011 12:09 pm
Your car is a: 1980 Fiat Pininfarina Spider 2000 F.I.
Location: Ottawa, Ontario, Canada

Re: Original Jack placement and install?

Post by 4uall »

Jay

Fiona
1980 FI 2000 Spider
ITZEBTZE

https://goo.gl/photos/eNKaX7hrXhBu9fmp6

FINN (FN-2187)
2014 Jeep Wrangler Sport
MYTHERPY
Betis
Posts: 109
Joined: Mon Nov 30, 2015 11:17 pm
Your car is a: 1981 Fiat 124 Spider FI

Re: Original Jack placement and install?

Post by Betis »

Does anybody sell the strap?
Betis
Posts: 109
Joined: Mon Nov 30, 2015 11:17 pm
Your car is a: 1981 Fiat 124 Spider FI

Re: Original Jack placement and install?

Post by Betis »

Found one thanks
User avatar
RRoller123
Patron 2020
Patron 2020
Posts: 8179
Joined: Sun Nov 13, 2011 2:04 pm
Your car is a: 1980 FI SPIDER 2000
Location: SAGAMORE BEACH, MA USA

Re: Original Jack placement and install?

Post by RRoller123 »

My opinion is that if we actually carry it this way, it will wobble around and bung the fender from the inside. It is a precarious setup for sure, and the plate that the jack sits on is weak and the whole stackup wobbles. I only put mine in place for cruise nights, etc. Carry it elsewhere for general driving. The owner's manual does NOT show the configuration in the picture. It shows the plastic toolbox being held down by the jack. So I built a small wooden box and attached it to the rear bulkhead, to carry the various bits necessary when roaming.

Image

Image

Image

Image
'80 FI Spider 2000
'74 and '79 X1/9 (past)
'75 BMW R75/6
2011 Chevy Malibu (daily driver)
2010 Chevy Silverado 2500HD Ext Cab 4WD/STD BED
2002 Edgewater 175CC 80HP 4-Stroke Yamaha
2003 Jaguar XK8
2003 Jaguar XKR
2021 Jayco 22RB
2019 Bianchi Torino Bicycle
User avatar
johndemar
Posts: 716
Joined: Sun Feb 24, 2008 11:12 am
Your car is a: 1976 Fiat 124 Spider
Location: Phoenix

Re: Original Jack placement and install?

Post by johndemar »

Each year may have been a little different.
My 76 has the jack and rubber strap on the right wheel well and the tool box and the rubber strap on the left wheel well.
76 Fiat 124 Spider
One owner since July 20, 1976
Amadio Motor, Jeannette, PA
DieselSpider
Posts: 2130
Joined: Wed Dec 24, 2014 10:21 pm
Your car is a: 1978 124 Spider with Isuzu Turbo Diesel

Re: Original Jack placement and install?

Post by DieselSpider »

johndemar wrote:Each year may have been a little different.
My 76 has the jack and rubber strap on the right wheel well and the tool box and the rubber strap on the left wheel well.
Same as on the 77 and 78.
TX82FIAT
Posts: 1814
Joined: Mon May 03, 2010 11:04 am
Your car is a: 82 Fiat Spider 2000 CSO
Location: San Antonio

Re: Original Jack placement and install?

Post by TX82FIAT »

In he early 90's I noticed a small ding appear one day on my passenger side fender when getting out of the car. I had just washed the car minutes before and knew it was not there before the drive and I had not hit anything. The jack had shifted and created the smallest of dings that most likely only I could see. From that point on I wrapped the jack a few times in a towel wedging it into the proper spot. Since it is tucked away behind the panel not ugly eye sore. Benefit of a towel in the car at all times. Three spiders later and I still wrap the jack in a towel and wedge it so it will not move. I know, not ideal.... but nobody sees the jack or the towel.
Buon giro a tutti! - enjoy the ride!

82 Fiat Spider 2000
03 BMW M3
07 Chevy Suburban
superbenk
Posts: 40
Joined: Mon Apr 20, 2015 7:01 pm
Your car is a: 1978 Fiat 124 Spider

Re: Original Jack placement and install?

Post by superbenk »

Make sure you strap it down! Mine wasn't when I bought the car & now I have little punched out dents in the fender where the jack bounced against the inside of the fender. :cry:
njoconnor
Posts: 614
Joined: Thu Jul 05, 2012 7:06 pm
Your car is a: 1972 124 Spider

Re: Original Jack placement and install?

Post by njoconnor »

DieselSpider wrote:
johndemar wrote:Each year may have been a little different.
My 76 has the jack and rubber strap on the right wheel well and the tool box and the rubber strap on the left wheel well.
Same as on the 77 and 78.
Ditto my 72.

Neil
Neil O'Connor
Madison, WI
72 FIAT 124 Spider
12 Jeep Grand Cherokee Overland Summit
14 Ram 1500 Laramie Longhorn Eco-Diesel
ex-71 FIAT 124 Coupe
and a host of Audi's, Saabs, VW's, MOPAR's, Fords, and a Bimmer....
Post Reply