overheating problem (and some questions)

azruss · Post by **azruss** » Fri Oct 17, 2014 3:56 pm

the overheat light is in the gage itself.

kacperix · Post by **kacperix** » Fri Oct 17, 2014 5:34 pm

what about changing connector between sensor and results?
What do You think?

azruss · Post by **azruss** » Fri Oct 17, 2014 8:46 pm

the light sensor is a straight on/off switch. Your gage would go from nothing to everything as soon as it overheats.

kacperix · Post by **kacperix** » Sat Oct 18, 2014 3:30 am

i didn't swap the sensor, only do cabling..
in my uderstanding if cable which was in the past responsible for the temperatur measuring is disconected now the temprature indicator on a gauge shouldn't move any where just lie on 120degree F. And if i connect cable responsible in the past for the light to the sensor, the light should be on /off...
on the movie guy said that if we mix the cable, cars start to ovearheat so simmilar to my situation..
https://www.youtube.com/watch?v=8DtcIlkt4BY

in my opinnion it's more propably that somebody mix the cables on the gauge not on the engine//

overheating problem (and some questions)

Re: overheating problem (and some questions)

Re: overheating problem (and some questions)

Re: overheating problem (and some questions)

Re: overheating problem (and some questions)