Hi All,
Installing my new roof and before I glue anything I have been trying make sure all is aligned.
My driver window fits well.
Passenger window seems off. The top of the window contacts the bright-work on the rear quarter window at the top only.
Can I adjust this? Looking at the assembly I do not see any obvious points of adjustment.
Thanks,
Jordan
Rear quarter glass frame adjust?
-
- Posts: 371
- Joined: Fri Feb 22, 2008 5:38 pm
- Your car is a: 1981 FIAT Spider 2000
- Location: Victoria, BC
-
- Posts: 3996
- Joined: Sat May 23, 2009 1:23 pm
- Your car is a: 1971 124 Spider
- Location: Texas, USA
Re: Rear quarter glass frame adjust?
Is the door's window all the way forward? Sometimes the window regulator wires get loose and the window can slip back, or either the back or front be lower.
Csaba
'71 124 Spider, much modified
'17 124 Abarth, silver
http://italiancarclub.com/csaba/
Co-owner of the best dang Fiat parts place in town
'71 124 Spider, much modified
'17 124 Abarth, silver
http://italiancarclub.com/csaba/
Co-owner of the best dang Fiat parts place in town
- bradartigue
- Posts: 2183
- Joined: Thu Sep 20, 2007 2:35 pm
- Your car is a: 1970 Sport Spider
- Location: Atlanta, GA
Re: Rear quarter glass frame adjust?
Unless your door is hung wrong or the top frame is installed incorrectly then the adjustment is the forward vent window, then the window on its track.
1970 124 Spider
http://www.artigue.com/fiat
http://www.artigue.com/fiat
-
- Posts: 371
- Joined: Fri Feb 22, 2008 5:38 pm
- Your car is a: 1981 FIAT Spider 2000
- Location: Victoria, BC
Re: Rear quarter glass frame adjust?
Yesterday I had a chance to get back to this.
Thanks Brad, I adjusted the window mechanism at the front quarter glass and it is looking better. Not perfect but better.
I will check the mounting bolts at the frame itself, I may be able to move the assembly back a little to finish this up nicely.
Thanks Brad, I adjusted the window mechanism at the front quarter glass and it is looking better. Not perfect but better.
I will check the mounting bolts at the frame itself, I may be able to move the assembly back a little to finish this up nicely.