Location of Pininfarina 'F' badges

[MrClancy]

Could anyone please provide measurements of where the F badges should be? The PO of my car put new sheet metal in where the badges go, so I need to put them back in the correct spot. A measurement of the lower edge of the badge from the chrome sill strip would be helpful. And then the other measurement I could use would be the distance in along that same chrome strip (to the center of the badge)from the end of the strip closest to the rear wheel fender arch; that would then give the me correct position in the panel. Many thanks if someone wouldn't mind getting out a tape measure to figure this out!!

[focodave]

Mr. Clancy,
I measured mine just a few minutes ago.
Left side of vehicle:
From the bottom edge of my emblem, to the top of the chrome strip, is 1.5".
From the lower right-hand corner of my emblem, straight over to the edge of the wheel opening, in a horizontal plane level to the ground, I measure 7.0".
Dave

[MrClancy]

How awesome it that!! Thank you SO much! What a great help that is! Thanks!!!